...which use balanced +4dbv line input level. Amplifier which have 3 pin XLR connectors for input signals can accept that high level signal. For home style HiFi amplifiers, the signal level is ...
Question about Behringer Music
behringer xenyx x2442usb main bus meters not showing signal when sending any source to the main mix bus I am not getting the main bus to show its output on the vu meters. Everything else works as far ...
Question about Allen & Heath Music
I have an Allen & Heath ZED428 and it's left main output randomly switch's between sending no signal or very distorted signal. I tested multiple cables and speakers and determined the problem is with ...
...but you can read it online.THESE words are written on page 9 of the manual," If you are recording a signal via the TAPE OUTPUT and wish to listen to this simultaneously via the CD/TAPE INPUT, do not ...
Question about Music
...in my phone and play the music no sound will come out, just a humming noise. Check that you DO have signal from the phone.. Some smart phones 'autodetect' an earphone and won't drive a signal wire.. ...
marshall mg 100hfx preamp board not working You need to signal test this board to confirm if the analogue preamp IC or any logic gate has failed.Otherwise the only option is to replace the board. ...
can't send instruments (live or recordings) to the tape output.. (does not see signal in Cubasis) Anything you hear in the mains SHOULD come out the "tape out" jacks UNLESS you have the "tape to mains
...much gain saturates the electronics. The noisegate really only works to eliminate noise when input signal is below a certain level... it is NOT used or effective when at high signal levels. If you ...
Question about The Music
I have a Pyramid GA810 guitar amp. No signal out of preamp. I cleaned all the pots and input jacks. I used a signal tracer and only have a signal to the first pot, (gain). Any thoughts? Based on the ...
Question about Peavey Music
On a Peavey PV-1.3K amp, can I connect 2 different signals via each input on a channel to be summed in the output of that channel or should the second input only be used to parralel the signal off? ...
141 questions posted
Usually answered in minutes!
35 Questions
24 Questions
14 Questions
13 Questions