...You need to measure the rotor and stator for correct resistance and shorts. You will need a good ohm meter and teh exact readings mostly on a rotor approx 22ohm and stator can be less than 1 ohm, ...
Question about Coleman Electrical Supplies
...powermate PM0495503, and it has four wires coming from the stator. 2 blacks and 2 whites. When I ohm them out, one white ohms through to one black and the other white ohms through to the other ...
how to test stator You will need a very high quality ohm meter that can account for test lead resisitance. Stator wire leads are ohmed right off the stator and their value is generally low 0.8 or less
Question about Kohler Electrical Supplies
...transfer switch RXT will not auto start? Disconnect generator remote start wires in the ATS. Put an ohm meter across the remote start terminals in the ATS and kill utility power, you should here a ...
...test at 125 uf rating on the cap says 130 is this ok? The exciter coil can be checked with an ohm meter. It will read fairly low ohms (probably under 100). There are diodes also. You can check ...
how do you check diodes? You check the diodes with a quality Ohm meter, you should have zero ohms in one direction, reverse the test leads on the diode and you should have a high resistance, it may be
Question about Briggs & Stratton Electrical Supplies
I have a generator that does not produce any volts. I replaced the brush block because it was bad with no help. I took resistance readings of the rotor and stator. Are these in spec?? briggs and ...
Question about Kohler Electrical Supplies
...to prevent a bad reading. You MUST have a good meter, cheap ones will not do. Put the meter on Ohms and put the probes together, note reading (this is the resisitance of the meter wires and this ...
Question about Mr Steam Electrical Supplies
...This is a resistive type sensor that communicates the temperature in the room to the controller via ohm ratings. There is an equivalent ohm rating for every degree of temperature it correlates to and ...
no voltage engine ok stator=0.7 ohm blue wire 1 ohm rotor diodes ok welding ok. condensator ok . give approx. 3.5 votls a the output merci might need to excite the generator with a drill.
696 questions posted
Usually answered in minutes!
64 Questions
57 Questions
47 Questions