Alpine SPS-600C Car Component System "wire amp" Questions

...the amp. Then just the positive and negative wire from speaker to amp. Use Speaker Positive wire to Amp Right Channel Positive And speaker negative wire to amp Left Channel Legative wire. That is

...wire, the amp will never shut off. You would have to wire a switch inline with it. Plus, if this is the remote amp turn on, they are usually less than 1 amp. If you over amp the remote wire, the amp ...

...amp. Wire them in parallel so the amps see two ohms (wiring in series will show four ohms). Doing this effectively "doubles" the power of the amps. If the amps are not two-ohm stable, they'll fail. ...

amp should have a wire connection that says remote,p.con, or antenna. and its usually the smallest wire connector located by the power and ground wire. this wire goes to the solid blue wire coming out

wire a amp into a 2002 landcrusier stock headunit cheers yes, there is an amp turn-on wire from the head unit (black with a red stripe). You will need to add a power wire and fuse from the fuse box to

...amp and wire to the POS terminal of first speaker. Take the NEG terminal from the amp and wire to the 2nd speakers' NEG terminal. Then place a "jumper" piece of speaker wire to connect 1st speakers' ...

...AMP. Run a 4 guage wire from this terminal and fasten it to some bare metal in your trunk. Not more than three feet. RCOM /Remote - There will be a small gauge wire from the back of your stereo that ...

amp but I dont know how to wire it. Any help is great. Thanks The subs can be wired "parralel" or in a "series". it depends on the ohm rating of the speakers and the amp. Most amps can only go down to

...WIRE FROM ONE POSITIVE TERMINAL TO THE OTHER SAME FOR NEG) BUT RUN WIRES FROM THE AMP IN PARALLEL TO THE SUBS (SET OF WIRES FROM THE TERMINAL OF THE AMP TO EACH SUB) PERFECT SET UP SINCE IT ALLOWS ...

...bring the info of your sub and amp...also if you not familiar with wire connectors be sure to ask if the connectors you need are included, and maybe ask about tools if you have not done this