Vestax Vci 100 Midi Controller "pin" Questions

Ad

...it up with 2 test leads on the ends- attach one to ground.Now your TL072 op amps have 2 outputs, pin1 and pin 7.  The inputs for pin 1 are pins 2 and 3, and the inputs for the amp section ...

Ad

Question about Pro Line Music

1 Answer

i have the PL400 stand and cannot open it. there is the long pin but it won't budge, Can you help The pins can be sticky. You squeeze the pin extending out upward toward the top cross member to ...

Ad

...change any patches however it does power it up. can any one help? It is LIKELY that one or more pins and or wires in the remote cable are broken. These MINI DIN connectors are "tender" and are ...

Question about Roland Music

1 Answer

Need a 6 pin cable for Roland JX-3P I need to replace the 6 pin cable that conects the jx-3p to the pg-200 but no one around here has one. Any ideas? Make your own cable! Check this connector or ...

battery drains quickly - The jack acoustic side does not turn off when guitar cable is removed It's possible that the socket loosened and rotated creating a short between two pins. Remove socket and ...

...balanced cable, Ive re-solderd both ends twice to be sure the wires are solderd to the correct pins and I'm still getting the same reading.. I know this reading is correct for a mono unbalanced ...

Question about Peavey Music

1 Answer

repair Help Powered Mixer turns on,has but no output.. Hi, As a test procedure check for -15V at pin 4 of one Opamp, chip of 8-pin and +15V at pin 8, if you have those then it may be your output ...

Question about Eliminator Music

1 Answer

Broken coder pin..where does it belong inside Coder pin? Never heard of that... do you mean Cotter pin? They go through holes in shafts to lock collars to shaft, etc. SOMETIMES they are actually used ...

Question about Peavey Music

1 Answer

...chassis. There will usually be two other wires, often black and white that connect to the other two pins. From the back of the connector, with the center pin tied to the grenn wire of the triangle ...

...degree C... so at reasonable temp we should see around a .75 volt max here. The voltage at IC200 pin 3 should be the division from the 6.2 volt Zener source or around 0.86 volts. If temp goes up, ...

Not finding what you are looking for?
Vestax Vci 100 Midi Controller Logo

27 questions posted

Ask a Question

Usually answered in minutes!

Top Vestax Music Experts

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66967 Answers

Are you a Vestax Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...