Brother MFC-7440N Laser Printer "paper draw sticking" Questions

...paper draw. Power off the machine then stick a screw driver into the hole, there is a spring release for manual release. If this is a small tray then you can disconnect the draw from the copier 4 ...

...paper Thick 3 cant print thick three paper in duplex unless you go manual print one side stick in draw then print other side thick three is like a pizza box duplexer for a 350 is less 6" of

...draw full of paper. The original problem was that the printer would not properly pick up paper, & the jam light came on almost immediately (The paper was bent into a horseshoe, but did not pass the ...

...original ALWAYS pull the original out in the same direction as the flow of the document. Try sticking a business card down thru the way the paper flows you mite be able to reset the offending

...paper in a three inch length (so you have a piece 13" x 3") . Draw a line at 1.5 inches and place some sort of adhesive (I use a double sided tape gun) on one side of the line. Line up the ...

...another size...do that again or until it changes to letter size. The leave it alone. You may have to do that everytime you add paper an reinsert the draw unless you replace that card. Hope this

paper tray. At the computer, type a single space on a blank document, with no headers or footers, then print the blank page (trying to print with nothing at all usually doesn't work). This should pick

...ink your printer. In an inkjet printer, liquid pigment is sprayed from print heads directly on the paper where it dries and makes an image. Your printer has toner, which is a pigmented powder. I'm ...

...paper and the light went off. Hope this helps someone. I also tried sticking my fingers in and rolling the rolers round. This seemed to free things up a bit. i got this suggestion off of ...

Will not feed paper. HP Photosmart 2575 HP Photosmart 2575 Will not feed paper This is a very common problem. Apparently HP changed the roller because of this fault. I've tried cleaning, I've tried ...