...Tray 3....but the tray does lift Start by pulling out tray 2 and setting it on the floor. Next take out tray 3 and slide it into tray 2. Print from tray 2. If it works, take the tray on the floor and ...
...Tray 3 "forgets" paper size. The detents were enhanced to assure contact with limited results. Now we want to remove tray 3 for access to to the detents for service and can't get the tray to separate ...
Tray 3 open or Empty Hello, i am using a HP LaserJet 2430 dtn. I am getting the message 'Tray 3 open or Empty'. Can someone please help me. Thanks While tray 3 is detachable, when I remove it from my ...
Question about HP LaserJet Office Equipment & Supplies
...tray 2 or 3 default, or make the printer stop choosing tray 1. Im able to manual switch the print from tray 1 to 2 or 3 while its waiting for manual feed, but it doesnt come out right. please help ...
Question about HP LaserJet Office Equipment & Supplies
Tray 3 (bond). Need to Configure HP 4050 printer to prompt 'load paper' when tray 2 is empty. Both trays have letter size. You'll have to change the paper TYPE of tray 3 to a different type as in tray
Question about HP LaserJet Office Equipment & Supplies
...tray 3 I have plain paper. I would like to default to tray 3. 1) When the printer receives a print job, it selects the tray by trying to match the requested paper type and size with what has been ...
Question about HP LaserJet Office Equipment & Supplies
...tray 3 empty, always but have paper in tray 3 CAUSE: This error message indicates the paper present sensor flag in one of the trays does not detect paper in the tray. This could be caused by one of ...
Question about HP LaserJet Office Equipment & Supplies
...tray 2 & 3 have same size/type, will pull paper from 3 until empty. Make sure that the tray selection (or paper type) in the printer driver or software application is set correctly. (The printer ...
Question about HP LaserJet Office Equipment & Supplies
tray 3 is not showing up at all in the printer properties dialog box. Any suggestions? tray 3 not showing up in the properties box for my hp 4200 Have you re-installed the driver recently? Perhaps you
...3 Verify that the tray 2 lifter wire-harness is full seated in its connector on the dc controller PCA (location J93). 4 Replace the tray 2 lifter-driver assembly. See Tray 2 lifter-drive assembly. 5 ...
220 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions