...e007 DearThis error arises due to the rotation sensor of the sleeve at fixing assy. The fixing film assy.to be replaced or the film (to minimise the cost)may be replaced if the heater contact points ...
...e007 in canon ir2016 There is most likely an error in the rotation of the fixing film detected. Or, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing ...
e007 error means Fixing film rotation error the fixing film in the fuser unit is not rotating or is defective. Solution is to change fixing unit , part number: 3FFM2-3352-00000 (STK FIXXING ASSY) Hope
Question about Canon Office Equipment & Supplies
...E007 I have replaced the fixing film and the fixing film sensor for this copier but the E007 still appear on the screen. take out fixing unit, drive it manually if fixing film do not rotate- apply ...
...E007 - Fixing film rotation error You have to disassemble fuser unit and inspect a fixing film, if damaged - replace. The official documentation says: E007 0000 Fixing film sensor failure The fixing ...
Question about Canon Office Equipment & Supplies
...E007 Fixing film rotation error Inspect fixing film for damages Main Cause/Symptom: Fixing film sensor failure Countermeasure: - Check the connector of the fixing film sensor. - Replace the fixing ...
Question about Canon Office Equipment & Supplies
E007 means an error in the rotation of the fixing film has been detected. The reading of the main thermistor is 100°C or higher and the fixing film sensor does not detect the rotation of the film
...E007-0000 ABNORMALLY LOW TEMPERATURE (detected by sub thermistor) A fixing film sensor failure has been detected. Fixing film rotation error C: Fixing film sensor failure The fixing film sensor is ...
...E007 means that the fixing film sensor cant detect rotation of fixing film. In most cases because the white mark on the left end of foil is damaged.But also when the fixing film does not rotate well ...
...E007 Fixing film rotation error). The fixing film sensor is faulty. - Check the connector of the fixing film sensor. - Replace the fixing film sensor. - Replace the DC controller PCB. Normally you ...
751 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions