Jandy Lite2 LG400 Ceramic Compact Heater "pump flow" Questions

...pump are good No flow out of either pump, even when disconnected from nozzle! What else can be wrong? No even one drop of flow. Must leave at 4:40 Sat. Back Sun. Are you referring to an oil pump? If ...

...pump wasn't activated. Flow from tank is ok-screen is clean-float shuts flow into bowl Help please Paul you are describing a vented kerosene heater could be a monitor or a toyotomi. unit goes through ...

...flow. Causes are blockeed filters or you water pump from the bore starting to fail. I would expect you to have a large filter somewhere on the water line from the well. Try and find it and clean it ...

...pump in to boiler are out. most moder boilers are pumped on the flow out however if it is an open vented system the vent over the tank should be fully open with no valves or pump between it and the ...

...Water in fuel low fuel Incorrect air pump pressure Restricted fuel flow Air loss between the pump & the nozzle Vacuum loss between the tank & nozzleRead these troubleshooting ...

...the pump and the nozzle. The air pressure/flow is directly related to fuel flow. Instructions for checking the pressure can be seen on the ReddyParts.com website ...

...NO fuel, check the pump rotor- it may be broken. If SOME fuel, then set the pump pressure. Air pump pressure is directly relayed to proper fuel flow. Instructions ...

...I WAS THINKIN PROBLUM WITH WATER FLOW PUMP NOT WORKING OR CLOGGED OR FLAME SENSOR DIRTY OR GOING BAD SHUTTING FLAME OFF WITHOUT GOING UP TO TEMP PLEASE HELP! check the flow sensor may be an air

...flow check the pump. Pressure out is critical. 5. If pressure is too low check for leaks around the pump. Spray soapy water on the back side of the motor/pump housing. The plastic pump cover is bad ...

...pump controls the air/fuel mixture. 2. remove nozzle and clean with brush and compressed air. Also inspect rear of combustion chamber where air flows into and around the chamber to ensure proper air ...