ton AC unit? What wire size do I need to run for a 3 1/2 ton AC unit? it depends on the distance from main power source # 8 if more than 40 feet look at starting amps then google a wire sizing voltage
...ac has been in you may want to replace it with a 2.5 ton due to the damage to the compressor valves because of the mis match. or if the indoor is newer and the original system may have been a 3 ton ...
Question about LG Heating & Cooling
...STARTING CAPACITOR AND RUNNING CAPACITOR, AND WHICH CAPACITY RUNNING CAPACITOR WILL BE SUITABLE FOR 1.5 TON AC? you can't mismatch capacitors on a unit. cause premature failure of componente in ...
Question about Samsung Heating & Cooling
Ton Samsung Bio-Sleep AC. It stops every five minutes and restarts after a while. I have an Everest Stabilizeer for my AC. Is this an AC problem or a Voltage...? I am really confused. Arun i hanve 1.5
...ton AC unit in 220 volt? It will be good to have a 3sqmm wire for the power line but if the line is going to be longer then increase the size to the next level. This is because the AC on start up ...
...ac (3 ton) and up needs a generator of 10000 watts minimum to handle starting trque. they also need a hard start kit to boost starting voltage.for god sake someone reply and tell me what a good job i ...
Question about Heating & Cooling
Ton heat pump, SEER 14 installed in my department about 4 months ago. I've noticed that the AC has a regular pattern running in the on/off cycle and that i Dear Sir,I have an Amana Distinction 2.0
TON AC as the old AC was 2 and half ton. Since the new system was installed in the winter time it was not until the hot weather started in May that a problem arose. The first conclusion of the problem
Question about Heating & Cooling
...ton AC unit open the service panel to check for control voltage of 24volts when tstat calling, The contactor should be pulled in, if contactor is down,and contacts appear to be clean, and the unit is ...
Question about Heating & Cooling
...ac 3.ton showing on display light blinking..what is problem could be a control board either in the inside unit or the outside unit could be a simple start/run capacitor for the out side unit best get ...
18 questions posted
Usually answered in minutes!
347 Questions
334 Questions
307 Questions
96 Questions
89 Questions