...broken lid switch on a kenmore washer. a piece of plastic that is part of the switch where one of the two screws secures it is broken. The switch actually works, but it is loose because of the broken ...
switch does not have continuity, replace it. Parts Cause 2Motor Coupling The motor coupling connects the motor to the washing machine transmission. If the washer is overloaded, the motor coupling will
...switch is broken. Can turn it on by holding the inner switch but the chrome outer sw is stripped an spins on shaft. Washer Start Button Replacement -GE Top-Load Washing ... ? 2:05 ...
...switch is broken. This fragile plastic switch normally gets pushed in when the door is closed. Without this switch being pushed in, the washing machine won't start. The plastic pin on mine has broken ...
...switch on the electonics board has broken and the machine won't start. CAn i replace the switch or do i have to buy a whole new power board in order to get it going? Look if you can get a switch that ...
...switch broken. It may need to be replaced. - Motor broken. QUite expensive repair, the motor needs to be replaced. - Timer broken. Check the lid is correctly closed, perhaps the lid switch is having ...
switch, a broken belt, or a problem with the motor. Note: direct-drive washing machines do not have belts. 1) Check the spin cycle. If this works, the motor is operating and the belt is not broken. If
broken door sensor switch my whirlpool topload washer was stopping right before the spin cycle, after pressing the door switch down it would start up and finish the cycle. Now that switch has cracked ...
...just stoped it happen to me 1 time and it was the door switch that got broken. if it is top load machine check if the door switch is broken, the lid most of the time fall down and break the
196 questions posted
Usually answered in minutes!
50 Questions
40 Questions
42 Questions
24 Questions