Electrolux Kenmore 3.5 cu. ft. I.E.C. High-Efficiency Front Load Washer / Dryer "faulty lid switch washer" Questions

...Lid switch faulty, door switch faulty. 3. Start switch and or timer faulty. 4. Washer motor faulty. 5. Main control board faulty or shorted. Power to Washer Be sure the washer is plugged into the ...

faulty lid switch or spin cycle sensor. The lid switch is responsible for ensuring that the washer lid is closed before the machine starts filling or spinning. The spin cycle sensor controls the speed

lid switch is faulty. The washer has a lid switch that checks to see if the lid is open, if lid is open the washer will not start the wash cycle. Check/replace the lid switch and you should be back in

...faulty lid switch stop basket from spinning Lid switch is safety mechanism that cuts off power to motor when lid is open. If it is broken or faulty you will not get power to motor during spin. Hope ...

lid open. If the switch is faulty, it may prevent the washer from running at all. You can test the switch by opening and closing the lid while listening for a clicking sound. If you don't hear a click

...faulty!! The lid must be closed during operation. 3. Is there excessive sudsing? Always measure detergent. Follow manufacturer?s directions. 4 If you have very soft water, you might need to use less ...

...most likely the lid switch is faulty .there is a tab on the washer lid that lines up with the lid switch make sure it is lined up and switch is depressed . should hear a click ,if not replace

faulty. The lid switch is a safety feature that ensures that the washer does not operate if the lid is open. Check that the lid switch is not damaged, and that it is properly activated when the lid is

...lid frame. You normally have to raise or open the top or front of the washer to access the switch. It can be tested for continuity using a multimeter or ohm meter to see if it is faulty. Hope this ...

...faulty micro switch on the lid. Have the switch checked out and replaced if need be. Best wishes, Graemevm FYI, I disconnected the lid switch and it still did same thing. Agitates somewhat but not ...