...door. Take a long screw driver and stick it in the hole where the flame sensor wire goes and remove the screw holding the flame sensor in place. Clean the metal rod on the flame sensor ...
...door opens again, if the not then you have to take a screw driver and open the latch. After this the latch mechanism should be replaced as it is bad. Hope this helps...please post back for further ...
...door. Gently remove the receptical and its attached cable adapter. With your screw driver short the connector extension to the housing, just as the probe would. This should reset the meal temperature ...
door side) and finally remove the back panel. You will need a special screw driver as the screws are star type. I found out that there was some little water on the bottom panel of the oven. There is a
...driver to release the lock by entering through the latch lever spacebetween the door and the ovens outer frame. If this method fails, you may haveto remove the entire glass front panel and access the ...
35 questions posted
Usually answered in minutes!
27 Questions
2 Questions
2 Questions