pot with the sprayhead removed. Most Bunnomatics have two forms of heating. The primary heat source is the heater element. It's job is to heat water to the temperature set by Bunn factory technicians.
Question about Bunn GR Coffee Makers & Espresso Machines
...pot of clear water thhrough the machine, then turn the unit upside down over a sink (making sure it's unplugged first, and always keeping the fill hole down at all times) to let it drain out all the ...
Question about Bunn GR Coffee Makers & Espresso Machines
...pot of water through,to rinse.when done replace spray head .wait for it to heat up and your set to brew again... If no water comes out when you pour water into the tank, then the tank is not ...
...pot of coffee, making sure the brewer is not plugged in. keep filling the brewer until the water comes out the sprayhead, then plug it in and let it heat up, and you are ready to brew. By the way, ...
...pot of watter in and let run down into the tank, it leaks watter form the top out the bottom. I had the same problem. On mine (and probably yours) the problem was the seal between the (upper) plastic ...
Question about Bunn Coffee Makers & Espresso Machines
...heat or fill pot I have a BT-10-B Bunn Thermofresh that will not heat or fill the entire pot. It was given to me and I don't have a instruction manual either. Lots of times minerals clooect on the ...
...pot of COLD water in the top. For best results pour the brewed coffee into a pre-heated thermal server if you plan on holding the coffee for more than 10 minutes or so. Enjoy! The correct amount of ...
...pot. The Bunn brewers have a low wattage/keep warm heater so the actual heating element isn't doing all of the work over those long periods... it only kicks on when the temperature in the reservoir ...
...water. Try brewing a couple of cups of WHITE vinegar (NOT red vinegar) thru the pot MULTIPLE TIMES. For a third time, run the vinegar thru the pot ONLY half-way and let the vinegar sit in the pot (in ...
Question about Bunn Coffee Makers & Espresso Machines
...heat and blow the thermal fuse. Or at best have a half pot short brew as the water dried up. * Note leaving the brewer plugged in without brewing daily is not a good idea. The water evaporates and ...
54 questions posted
Usually answered in minutes!
1 Questions