...release the trigger.that is the needle jumps right up high that is when motor stalls if you adjust the pressureso that the "spiking" effect is minimal your machine will not stall ,..I hope that ...
...to spray By stalling you mean quit or bogs down until you release spray? The engine has to be on high speed and be in good tune with good gas to produced the horse power for the pump. A too small ...
...In fact when I pull back on the wand nozzle to activate the high pressure the engine usually stalls. Help! run the water engine off pull trigger be sure to get all air out thats what cured ...
...high pressure nozzel engine quits when I let go of the wand trigger. Found O-Ring on caberator bowl dammaged. PRESSURE CONTROL WOUND DOWN TOO FAR CAUSING IT TO SPIKE....WHEN YUO RELEASE TRIGGER ...
...stalls the pump has an unloader valve it has a check valve at the high pressure output port where you connect your hose and trigger gun remove the fitting inspect check valve it may be stuck open ...
Question about PowerStroke Garden
...stalls. It was out of oil so I refilled it. Water pressure is on high. It was working fine for about 1/2 an hour then stopped. From what i understand ,you might have a bad armature Armature partly ...
Question about Powerboss Garden
...stalls PROBLEM 2 when started water does not exit the high pressure nozzle but when I switch it off i see that the water path through the PW is not blockedas stated above i made sure that NO air was ...
...Most other problems are engine problems due to bad gas, carbureator, etc. the pressure is set too high -----back off the unloader valve a turn or ...
...stalls when released. Hi if it stop when the trigger is pulled the issue is with the motor. stopping is caused by , low revs on motor or low compression or poor spark, sometimes faulty carby. change ...
...stalls immediately when trigger is depressed ?? unloader is not going into bypass, most brands...discharge cone is located where water is discharged from pump, will require removing machined fitting ...
5 questions posted
Usually answered in minutes!