Euro-Pro Shark SC-505 Handheld Steam Vacuum "replacement plastic turn cap" Questions

...turn tends to melt the plastic end caps. Remove your brush roll, hold the ends with your fingers and try to spin the brush roll. If it does not spin freely then it is probably damaged or clogged up. ...

...turn and no suction in the base (floor attachment) belt seems to be on Lay the machine on the floor with the front side down. Undo the 3 large plastic screws with a coin of some sort, then remove ...

...lock the roller in position. Spin the roller by hand to make sure that the belt is aligned properly. Place the hood back on the front nozzle and turn the plastic screws to tighten. Have fun

...replacement is your best solution. You should also inspect the housing where the roller spins, specifically where the end caps sit; look for damage to the slots in the plastic, it the roller will not ...

...replacement. If it turns, be sure the brush control is set to the brush position and the filter is clean. The filter may be on top behind a clear plastic cap, or underneath in red plastic holder ...

...plastic caps and put a little WD-40 on the bearing, or any industrial lubricant, even new motor oil will work. After putting on the WD-40, I spun the roller end around a few times and the WD-40 ...

...plastic screw on each end, turn those and they will release those end caps and you will be able to remove the brush assembly in two pieces. one short and one long one. They are connected into a black ...

...replacement? Can the machine be used as is by taking the insert out of the cap and filling the reservoir through the opening? Is there a current manufacturer of this product? You need to completely ...

...turn, and the brush control is stuck on "off" I changed the belts, but the brush roll still will not spin. Also, the brush control is stuck in the "Off" position. This seems to be a common problem ...

...plastic housing is a cheap replacement but the nut that is attached to the motor is not, crack the plastic housing (looks kinda grayish right) AND ATTACH A VICE TO ONE AND A NEEDLE VICE TO THE LOWER ...