hot... The SHARK ELECTRONIC Iron is equipped with an electronic auto-off. The electronic auto-off switches the iron off if it has been left standing unmoved in any position (sideways, flat or upright)
Pump ok when tested directly on mains but, does not come on by switch on the iron. Thanks I have a genesis iron,it lights when it is on but does not become hot .it stays cold.What might be the problem
Question about Panasonic Irons
...It takes ample of time to iron clothes. Check the voltage at your power point, irons draw a lot of power. most irons have a temp setting switch cool med hot . If this a new iron return for
...hot the iron drooped on floor. Problems with an iron's electronic complements should be dealt with by an authorized service center. It typically is more cost effective to replace rather than ...
...irons the power switch will be included in the iron thermostat and on others the on/off switch will be a separate switch. In either case you will need to make sure that there is continuity, or the ...
...irons. It is the auto shut off that is not working properly and the only way to fix it is to have it disassembled and the switch hardwired to be on whenever the iron it plugged in. It is a thermal ...
...Switch On your Iron, Increase the heat controller Knob to the maximum so that the water boils and Place it Upside Down (As if you want to Iron) but dont let it touch the Pressing Table. Then keep ...
...switch it on as normal ...put control onto hot ... whilst holding iron handle bang it on to hard surface that should sort it.. u get fluff stuck between the stat contacts. hope this helps. BSC ...
black and decker steam iron #415 not hot enough - why black and decker steam iron #415 not hot enough the contact switch for heat control not get good contact or dirty need to clean.
108 questions posted
Usually answered in minutes!
202 Questions
1 Questions
15 Questions
17 Questions