Crossfire VR402 Car Audio Amplifier "stereo 4 rca" Questions

...1 (4 ohm) Speaker in bridged mode. There are other speaker configurations you could use but you cannot drop the load below 2 Ohm in stereo mode and no lower than 4 ohm in bridged mode. Hope this ...

...4 channel 400w pyle amp to pyle stereo. When I connect the high output connectors to the speaker connections on the back of my pyle stereo, I do not get power to the amp. I have 2 RCA cables labeled ...

...stereo unit-the other rca outputs are there in the event that you want to run a 2 or 4 channel amp to power the speakers that are generally located in the doors or back deck-with that set up properly ...

...stereo only has one rca out i have i two in to four rca cable the amps are 4 channels do you get a splitter Run a single wire to battery fit it to a distribution or connector block they normally come ...

...stereo A ground wire for the amplifier (again 4 or 8 gauge preferred) Walmart sells a Scosche kit that has all of the wiring as well as a basic diagram for about $25, but it does not include the ...

...4: Connect the REMOTE wire from your stereo to the same wire for your amp . (this enables the amp to turn on/off with your radio.. otherwise.. you will have alot of dead batteries) STEP 5: re-install ...

...4 Stereo @13.8V (RMS Continuous Power) ChannelFlex Crossover Adjustable High-Pass Frequency (50-200Hz, L/R Independent) Low-Pass Frequency (120Hz) Adjustable Bass-Boost Level (45Hz, 0-9dB, F/R ...

4 gauge power wire w a 20 amp fuse hooked up to a kenwood stereo/bridgeable amp 350 watts max power model #kac~6295 it just dnt sound rite any sugestions? make sure you run your power and ground wires

...4 channel system by myself. I wired the speaker out put wires from my pioneer stereo to the amp input and ran my own wires from my speakers to the amp. I plugged everything in and encountered a ...

...4 ohms stereo 280 watts x 2 @ 2 ohms stereo 560 watts x 1 @ 4 ohms mono Volt Meter With Blue Illumination PWM MOSFET Power Supply Double Sided Glass Epoxy Circuit Board THD: 0.02% S/N Ratio: >100dB ...