Crown CE2000 2-Channel Amplifier "fault" Questions

...(or download a copy from the Crown web site, and then read it). You'll see that the RJ11 is for fault monitoring. The feature allows a remote fault indicator circuit to be installed some distance ...

channel 2 stuck on fault. plays for about 5min then fault light comes on, so now channel 2 does'nt play when fault comes on output stages faulty

...or is it bad? Since there's no make or model number all I can say is that happens when there is a fault. The fault might be caused by bad speaker wiring, such as two wires touching causing a short. ...

...if the output of the amplifier goes to a high constant voltage (DC) because of some internal fault. This is a rare fault although detecting it could just save those expensive loudspeakers. Due ...

gem sound amplifier #exa 1005 amplifier quit,had fault lights on please disconnect your speaker from amp first-if fault goen connect your speaker one by one until you find the bad one-check the cable ...

intermitant loss of sound on right channel This fault has been looked at by BBTOAST. But no joy so far..he has told me to test with metre. comparing results with good left channel. But because the ...

Fault lights on It is possible that the amplifier had encountered a fault with a higher current drain which had triggered it to a protection fault condition. The fault can be with your output drivers.

...but within a second or two it switches itself to standby mode and does not work. Solutions? This fault may be similar to a Harmon Kardon AVR1550 fault I recently encountered. I did all the usual ...

The fault lights are blinking. No audio The fault lights are blinking. No audio output. How can we troublshoot? Have read the fault conditions, but not sure how to determine which condition it is. If ...

...or without load, it is possible that some errors are on in the protect circuit. Look for possible fault in capacitorrs in this circuit. If not the powering of the outputs can cause the intermittent ...