JRC Radar Scanner when rotating is noisy inside the scanner base. There is a seal on the antenna scanner shaft, just below the seal there are two bearings, thou the antenna are enclossed moisture ...
1621 radar will not show target unit turns on, scanner turns, screen displays, does not display immage of target Could be the video wires in the radar cable
user manual for uniden bearcat ubc92xlt Thank you for your questions. Please find the user manual for the Uniden scanner here (it may take a few moments to load). It requires a PDF reader to view the ...
Question about Boating
I CLEANED THE EGR VALVE, PLUNGER WORKS GOOD, BUT ENGINE LITE STILL COMES ON WHY DOES THE ENGINE LITE STILL COME ON AFTER REALY CLEANING THE EGR VALVE? Probably not the EGR valve then. You need to scan
raymarine radar won't power up my C series (120) display shows "no data source" on the radar display. I have a 48 inch Raymarine open array scanner. It apparently is not receiving the signal from the ...
Question about Humminbird Boating
Where can I install the transducer for a lowrance hd down scanner on my ranger 621 I have the kicker motor on the right side the transducer for hds8 is glassed in I would suggest getting a transducer ...
furuno 1930 radar magnetron does not heat I need to know which wires supply the power to the magnetron heater. The scanner ( open array ) does not work properly when it is cold out, but works great ...
radar model 1830 fuse tripping when i diconnect terminal J 802 on scanner unit fuse does not trip bany more i do not have drawing after these terminals [email protected] we are now in cannaries
Question about Furuno Boating
How to fix "BRG SIG MISSING" error on an old FE-1505 MARK-2. ? Make sure the antenna/scanner is turning in tx mode. The bearing signal is generated inside the scanner drive motor. This problem usually
45 questions posted
Usually answered in minutes!
20 Questions
10 Questions
11 Questions
8 Questions