Bissell Proheat Upright Carpet Cleaner Roller Brush Assembly With End Caps 210-1128 - Genuine "ends" Questions

I bought a new plastic end piece for the hose but can't get the old one off the hose to change it??? Soak the end of the hose it very hot water to soften the end of the hose. Then insert a screwdiver ...

REMOVING HOSE END I HAVE A KIRBY G6 2001 LIMITED ADDITION- THE ENDS ON THE HOSE GOT CHEWED UP BY MY DOG. HOW DO I REMOVE THE END ON THE HOSE SO THAT I CAN REPLACE IT? I had to replace the hose end on ...

How to replace just the Kirby 210097 Hose End For G5 Series Vacuum Cleaner to hose. can buy replacement but can not get the broken end off simple and rquires no tools. Fill your sink with hot water ...

the float to my shop vac is shaped like a cup has an open end and a closed end. I would like to know if the float goes into the lid cage with the open end facing up or the closed end facing up It goes

...to belt, is off center which is keeping it from turning freely. The end cap is like a square. Other ends turns fine. Do these end caps come off? If so how? Can't get it to budge. This is exactly what ...

How do you clean/take apart the roller brush ends. One end turns easily, but the belt end is somewhat harder to turn. one end is usually fixed the other is not :pull staight out on the end with the ...

the brushroll, or the bearing in the cap got so hot that it melted the plastic end. Either way, the ends are not replaceable alone on these, a new brushroll must be purchased and installed, preferably

how to change coupling machine end Hi There, Alec from VacuumSpot here. If by coupling machine end you mean Kirby Hose End Piece <---- (This is a link so you can see the part), then it is really ...

...find hair wrapped around end pins) .... Spray again w/WD40 or a lubricating grease and put the ends back in (I used a hammer, again don't be afraid - it's metal and I've done it seveal times). I ...

hayden supervac I have a Hayden Supervac in my home. The Beaterbar will not rotate. I took it apart...tried manual rotation, will not turn. The right side appears frozen. Are there bearings in the end