Question about Husqvarna Sewing Machines
...bobbin is loose... Where is the bobbin control my bobbin is loose The bobbin spool is loose, the bobbin case is loose or the bobbin stitches are loose?????? If it is the last one - thread the machine ...
...loose and flips Bobbin tension is to loose, have tried numerous bobbin feels ok, then when machine runs and then jumps to a different part of design the bobbin flips Hai, I think you put the big size ...
...loose how is the bobbin tension adjusted? take off the plug open the small cover inder the base where needle sinks you will notice a round bobbin with a latch lift the latch and pull out the ...
bobbin case--check area for loose threads or lint the needle may be bent or damagedthread may be hanging up in bobbin case--check area for loose threads or lint upper tension may be to tightthe needle
...loose. Any suggestions? Check the bobbin tension and that the thread is tight around the bobbin. Make sure that the bobbin is in the right way around - the bobbin thread should double back on itself ...
bobbin casing. The large, loose stitches are normally caused by a problem with the bobbin case, a bobbin that is would properly, or when you're getting to the end of the bobbin's thread and the thread
...bobbin tension is too loose then adjust the tension screw on the bobbin case clockwise just a little bit until when you hold on to the thread and let go of the bobbin it doesn't fall free. Good ...
Question about Janome Sewing Machines
...bobbin thread is very loose, letting loops on the top. Top tension is set fine. When pulling bobbin thread, it is very loose, tried tightening the screw, but made no improvemwnt. Cleaned bottom of ...
Question about Elna Sewing Machines
loose bobbin case on an Elna 21C sewing machine? I recently got an old Elna 21C sewing machine. Cleaned and oiled it, it runs great, but the bobbin case is loose and won't pick up the thread to stitch
...is pulling more on top and your top tension is set between 4 and 5, the bobbin tension is too loose. If your top tension is set between 4 and 5 and it's pulling on the bottom, the bottom is too
12 questions posted
Usually answered in minutes!
760 Questions
564 Questions
372 Questions
252 Questions
263 Questions
