Hifonics BX1500D Car Audio Amplifier "amp ohm" Questions

ohm specs of the amp you can hook up parallel = pos to pos and neg to neg of the 2 speakres 2 - 8 ohm speakers in parallel = 4 omhs 2 - 4 ohm speakers in parallel = 2 ohms series = pos to neg of the 2

...ohm stable amp I have 2 12" dvc subs that are 4 ohm and a 2500 watt mono amp that is 2 ohm stable. How do I wire them to 2 ohms + on amp output to + on speaker #1 to + on speaker #2. - on amp output ...

...ohm amp i was wondering if i could connect a 2 ohm sub and a 4 ohm sub to a 2/1 channel 2 ohm amp. I presume you are talking about wiring one sub into each out put if so sure you can, but the 2 ohm ...

...amp. what ohm do i wire the subs to the amp depends how low your amps impedance goes down, if it can handle 2 ohm then you have to connect your speakers parallel to it (both speaker plus to amps plus ...

amp (actually, it'll do 1.5 Ohms). If you happen to have 2 Ohm single voice coil subs (not as likely) run them in series. Most amps will put out about twice as much power at 2 Ohms vs. 4, but this amp

...amp 1000w rms @ 2 ohm, do i need to figure out how to wire the dvc's @ 8 hom's to run the amp at 2 hom's? also my other question is if i ran paralell sub A pos terminal1 to sub A pos terminal2 to sub ...

amp that runs at 1 ohm create a greater demand on the vehicle's electrical system than the one running at 4 ohms? I am thinking they will have the same draw on the vehicle and the rate of inversion is

...parallel the resulting pairs to the amp for a final load of 1 ohm. Either of these amps will provide an honest 250 watts RMS to each L7. They'll not only rock your vehicle, they'll rock the

...amp is 2 ohm and the speaker is 4 ohm. Can I bridge by using 1 channel? A 2 ohm stable amp should be able to be bridged to 1 ohm (consult owner's manual for bridgability), but a 4 ohm speaker is a 4 ...

...amp is 1 ohm stable you can run + to +, - to - on each voice coil. Wire them into the box. Run +'s to +'s on amp, - to - on amp Other wise. If it is a 2 ohm stable amp, you run two 4 ohm dual voice ...