bass controller was weak. and i just have a little bass. I have used that rockford amplifier before. please tell me why the blue light is weak. Sounds a lot like you don't have it Grounded Enough. Did
bass hits it flashes Try a bigger amp. This one wants to be turned down. But seriously the protect can act like sort of a clipping device when the unit is trying to amplify out of a certain range. The
...bass notes hope this helps My uncl had the same problem and he went back to the audio shop twice...Then called me...I discovered that the powr cords they used were not thick enough,giving the amp a ...
bass hits @ higher volumes. I went to adjust the gain and now the amp goes into the same mode even with the gain all the way down as soon as you turn the HU up to 3/4 power???? The amp is not hot waht
...bass hits strong but gets weak and cuts off at the end? Any advice? First change the wire,and disconnect the subwoofers to check if the amplifier turn on without going in to protection mode,if the ...
...bass hit it would shut off then come back on then off again. It seems to work fine the split second that it's on so I'm hoping its not fried. The amp is a D7054. Any suggestions, please help. Called ...
...continued it would have blown your amp. Make sure the fuse is good as well. Perhaps it is getting weak. Turn things down and turn the amp on. Give it a chance to cool for a bit first and then turn ...
...bass control nobs are always at about 35% speaker is wired correctly to specs for the amp and speaker wire is good the power cable and grounds are ran in 8 gauge i know the specs say 4 gauge but im ...
weak that's it. And when installing the amp, it sparks like crazy when putting the neg in and then the pos or vice versa. Usually it sparks one time and then your good. But this time after replacement
215 questions posted
Usually answered in minutes!
131 Questions
85 Questions
67 Questions
48 Questions
46 Questions