Kicker IX404 Car Audio Amplifier "10 inch sub working" Questions

...10 inch sony xplod sub to my amp and it was working great for a couple of months then after a while the sub would just stop working and then come back on like ten minutes later and then after awhile ...

...10 inch comp kicker subs. The problem is the subs rattle and distort. The subs have been tested ok and all the wiring has been tested also ok. What could be causing these problems. The set up worked ...

...sub "sounds like crud" than the light turns red help me plese you masht seting all parameter too the midel befour selected oan by oan,step by step equalayzer 8 gauge reccommended make sure all ...

...10 inch boston fused subwoofer. i got in my car and my sub wasnt working. I checked the fuses in my sub and they were fine. Then i checked the fuses in my amp and they were both melted. i replaced ...

inch subs hooked up the a 600W amp. My subs were working fine, then all of a sudden, they stopped and the red light came on the amp. It's done this before, but always fixed itself. This time the light

10 inch sub, it's not likely to be able to produce sound much lower than 60-80Hz with any respectable volume. If you have the subsonic filter on and set to 60Hz, it will prevent a 40Hz tone from being

...10 inch subs which are mounted on a 1.5 inch thick board, side by side, and that fits over what used to be the trunk of the z28, actually it can hold four six packs stacked 2 x 2. Makes a perfect ...

...10 inch kicker comp 10 sub connected to it fuses are not blown but it is not working Chances are that you have internal problems with your amp, they have a 1 year warranty so I would check to see if ...

...10 inch L7 kicker subs with 4 guage throughout and a second battery in the trunk Make sure your frequency is no higher than 80 on the low and 120 on the high. Check speaker polarity with a AA ...

10 inch square pyle sub and its hooked up to the dub amplifier..the amplifier is in safe mode and the subs woint hit..what do i do to fix this? ok if the amp was in safe mode before the sub was hooked