2004 Toyota Sienna "remove rear lock" Questions

...rear seat on my sienna is locked in the down position. I've used the recommened reset by lifting the back with the strap and laying flat again but to no avail. Any help would be appreciated. I have ...

rear doors on my Toyota Sienna will not open either from the inside or out. Suggestions? The same thing happened to us. We have a 2000. The fix is easy, sort of. From the inside of the van, remove the

...remove the rear latch lock, 3 T30 torks bolts. Unsnap the cable from the 2 retaining clips and slide the power door assembly out the bottom of the door. Reverse assembly for the new one. Id imagine ...

...rear door cable broke. Back to square one. I just spoke to Toyota's national customer care and was told the "free part" was a one-time goodwill gesture. It sounds like we all need a class action ...

...Remove 2 large bolts, let tank fall Gently drag rear of tank from under the van to expose pump harness (you need only pull it out 6 - 8 inches) REMEMBER!! There are still gas fumes in the tank !! ...

...remove the cover. How to fix this is a problem. I just got this far yesterday. Here my plans 1) either toyota have this button and stock it and I buy it and try to replace it. or 2) have dealer ...

...remove the 2 screws that appeared once the arm rest is off. I think that's all the screws. Pry the bottom of the panel away from the door starting at the bottom back corner (you will feel where there ...

...rear, (hark? ill guess front is the passenger toes full of green slime<(a wild guess) now that is a big question, and is covered, in 4 places 100% factory service manual, FSM./ alldata.com (best) ...

...Remove the rear door trim panel. For additional information, refer to Section 501-05 . Trim Panel ?Rear Door, Expedition Removal Remove the power window switchplate (14524). Disconnect the electrical ...

...remove the rear liftgate lock cylinder from the vehicle to perform this repair. Reposition the rear liftgate lock cylinder wave washer and adjust the lock rod using the steps below. Verify the ...