...the starter connector. Remove the nut and disconnect the starter wire. Remove the 2 bolts and starter. INSTALL STARTER ASSY Torque: Bolt 37 Nm (378 kgf.cm, 27 ft.lbf) Nut 9.8 Nm (100 kgf.cm, 7
...Torque: 37 Nm (378 kgf-cm, 27 ft-lbf) for bolt 9.8 Nm (100 kgf-cm, 7 ft-lbf) for nut... INSTALL ENGINE UNDER COVER RH... CONNECT BATTERY NEGATIVE TERMINAL Torque: 5.4 Nm (55 kgf-cm, 48
Toyota 2E Engine: Torque setting for Cam sproket bolt Toyota 2E Engine: Please provide the torque setting for the Cam sproket bolt Torque: 59 N-m (600 kgf-cm, 43 ft-lbf)
...bolts. - Install the plate washer to each cylinder head bolt. - Using Torque wrench, install and uniformly tighten the ten cylinder head bolts in several passes. Torque: 60 N-m (610 kgf-cm, 44
...ft lbs (49 NM or 500kgf-cm), in a clockwise fashion, starting with the 2 center bolts. Second, mark the bolts with a paint mark, and then torque each of the 10 bolts an additional 90 degrees. Hope ...
cm, 44 ft-lbf) HINT: Cylinder head bolts are in length of 90 mm (3.54 in.) and 108 mm (4.25 in.). Install the 90 mm (3.54 in.) bolts (A) in intake manifold side positions. Install the 108 mm (4.25 in.
...block) :20Nm (200 kg.cm, 14 lb.ft) + 90° + 90°With new parts (even if only one thing is replaced) :64Nm (640 kg.cm, 46 lb.ft) + release+20Nm (200 kg.cm, 14 lb.ft) + 90° +
...M10 : 25Nm (250kg.cm, 18lb.ft)+(60°- 65°)+(60°- 65°) M12 : 30Nm (300kg.cm, 22 lb.ft)+(60°- 65°)+(60°-
...cm, 22 lb.ft)+90°+Release all bolts + 30 Nm(300kg.cm, 22 lb.ft)+90° In this instance you don't have a 'Torque to Spec"... you have a "torque to YIELD' In this specification, ...
...torque Torque 16 pieces at the both ends : 18.6 - 20.6 N·m (190 - 210kg·cm, 13.7 - 15.2 lb·ft) 24 pieces in the middle : 10 - 12 N·m (100 -120kg·cm, 7.38 - 8.85
1,816 questions posted
Usually answered in minutes!
1,231 Questions
1,236 Questions
819 Questions
767 Questions
792 Questions