...an air inlet servo, an air mix servo, and an air outlet servo. None of which control the temperature. The AC temp is controlled by a thermister in the cooler box/eveporator unit under the
...air control motor thingy on the inlet manifold ,iam tired and cannot think straight so this is last question ,remove the idle control motor valve and try cleaning it the fuel pump has gone out my 99 ...
Question about Oldsmobile Cars & Trucks
...inlet actuator.( is Recirc ) and and AUX motor damper drive. found the hybrid schematic for this car, the whole thing vac and electric. https://imgur.com/a/cHq4CCY ONE CAN WATCH EACH DAMPER MOVE OR ...
...service bulliten AC005-99. This is a expensive repair but if you just unplug the the air inlet servo motor(behind the glove box ) the air should start to work but without fresh/recirc
Question about Toyota Tacoma
...air inlet it vacuum servo. left and right mode actuator is electric motor drive. frost defrost is VACUUM servo drive./ the service manual has vacuum logic table matric showing all vacuum status, V or ...
Question about Toyota Tacoma
...inlet manifold and lets in more of less air depending on amount required by the engine ,it normally looks like a smallish round thing with a multiplug with 4 wires in it and this is controlling the ...
...air mix. If it is dirty spray it with electrical cleaner (this is a no residue fluid - do not use carb. choke cleaner or WD40 here) 2) check all tubing connected to the inlet manifold for leaks. I ...
air inlet hoses. Detach the electrical connector from the switchover valve and the remaining vacuum connections. Install the engine support fixture J28467-A with adapters J28467-450 or equivalents and
...Inlet Air Temperature Sensor Malfunction P1141 Slow Duty Solenoid- Malfunction P1145 Main Duty Solenoid- Malfunction P1146 Idle Co Potentiometer P1147 Accelerator Position Sensor (ETS) Circuit P1150 ...
...air inlet resonator and hoses as an assembly from the throttle body and air cleaner housing. If vehicle is equipped with speed control, unplug wiring harness connector from the speed control servo. ...
533 questions posted
Usually answered in minutes!
352 Questions
394 Questions
295 Questions
304 Questions
277 Questions