...runner limited blows cool to lukewarm air from heater. coolant is not low, both heater hoses going into firewall feel even temp with engine running. water temp control cable not working, but can ...
Question about Toyota 4Runner
...runner? added 1.7 qt. and volume still very low on dip stick. thanks bill use the level you attained after putting that much fluid in to tell you how much more to add. Start the car, leave it in park ...
...runner that I had to replace the head gaskets on do to the recall work over torqeing the headbolts. After replacing the gaskets I can't run it with the thermastat in with out it over heating. I put a ...
...05 Buick Rainier, power seat does not move front to back, everything else works (power, lumbar, heat, seat back and height), just the base does not move back to front. Memory keys work fine When ...
Question about Toyota 4Runner
...runner in the correct position then tighten the bolts.b) After replacing the plastic I used reinforced duct tape to seal any cuts I had madec) Put the heat shrink on to one of the cut ends of the ...
...heat (spark plugs, filters.) if you have P030x errors, eg: p0301 is cylinder #1 is misfiring (3 ways to do that not JUST spark) eg: P0300, random on all cylinders. (fuel mix wrong) or never tuned up. ...
Manual Section 303-01, Intake Manifold-Upper. (ALL 1999-2003). While the upper intake manifold is removed, check the Exhaust Gas Recirculation (EGR) orifices that are pressed into each primary port of
575 questions posted
Usually answered in minutes!
676 Questions
427 Questions
430 Questions
348 Questions
361 Questions
