1998 Toyota Corolla "water pump belt routing 98" Questions

...ac compressor)and then water pump and then alternator.but try to put it on the alternator first before the water pump u have to try to keep it on the water pump hold it while pull back on the ...

...diagram for 98 gmc suburban sepentine belt should be diagram on top of rad cover if not start with crank and go around water pump with back side of belt if its the rite belt can only fit one ...

Down to A/C compressor 5) Back to crank pulley 6) Forward around tensioner 7) Back glancing off of water pump 8) Back glancing off of ribbed idler 9) Up around alternator (where you started) Good luck

...5) Back to crank pulley 6) Forward around tensioner 7) Back glancing off of water pump 8) Back glancing off of ribbed idler 9) Up around alternator (where you started) Good luck! Hope this help : -

...water pump pulley because the wobbley idle pulley guides the belt half way off of the water pump as soon as i start the car. Also, the belt squeals when the car is at a stop and the A/C is running. ...

...water pump and the power steering pump, if necessary on the 3.1L engine. NOTE: For the 3.1L engine use a long 3 / 8 inch drive ratchet or breaker bar. For the 2.4L engine and 1999-00 3.1L engine, ...

...water pump, alternator, and engine crankshaft can result.? 11 Pry the idler or generator pulley to adjust the belt to specifications. 12 Tighten the idler or generator pulley fastener. 13 Start the ...

...water pump might be spinning the wrong way. Note: If you don't have a good floor jack, you can jack up the car, place a support under the oil pan, then slowly lower the car until the engine is ...

...water pump pulley and finally to the tension pulley. Tighten the tension pulley bolt. Once installed, there must be not slack in the timing belt. The belt teeth must be in perfect alignment with the ...

...water pump pulley. Remove the valve cover and the timing belt covers. Align the camshafts and install the camshaft alignment tool on the back of the camshafts as illustrated. Fig. 16: Align the ...