1997 Toyota 4Runner "checking resistance coil plug" Questions

resistance is typically high-about 7,000 - 12,000 ohms. It is specific for different coils, you would have to see the coil specs for your Toyota. Register for free at autozone.com, giving make, model,

...Resistance should be around 16-17.5k ohms (depends on length). FYI, each coil pack on your vehicle fires two spark plugs. The #6 spark plug is fired by the #3 cylinder coil pack, so if the coil pack ...

...resistance lowers. Less ohms. At 210 degrees, the ohms would be about .15 K ohms. The 89 and the 12 figures are wrong. I agree with gasitjr also if the sensor was bad He could have checked the temp ...

coil checks out resistance wise. having trouble finding a decent wiring diagram to continue troubleshooting. The most common reason to blow the 15 amp EFI fuse is moisture/rust on top of the fuel tank

...plug wire routing worn out distributor, that the spark scatters check each to make sure the engine is in good shape and no more misfire. good luck Hi, Simple as it may sound, there could be a number ...

use ohm meter to check secondary resistance.connect ohmmeter across the two secondary terminals of each coil. resistance 11.5-13.5 k-ohms. if all checks out test wires and plugs. hope this will help!!

CHECKING IGNITION COILS 1. Measurement of the primary coil resistance. Measure the resistance between connector terminals 3 and 1 (the coils at the No. 1 and No. 4 cylinder sides) of the ignition coil

Coil Resistance Check In addition to the test above, you may elect to perform an ignition coil resistance check as confirmation of the coil's condition. Check the ignition coil primary coil resistance

...coil winding resistance which normal resistance range is 0.5-0.7 ohms. If primary resistance is not within this range check out test results below. Ignition Coil Secondary Circuit Test With the ...

...checking the resistance across the windings, pay particular attention to the meter reading. if the reading is out of specifications, even if it is only slightly out, the coil or coil assembly should ...