...Disconnect them.4 Take out the entire seat assembly and place it on a dry, clean, flat surface. Position it so you can access the bottom of the seat. Undo the seat bottom's carpet flap ...
1999 chevy malibu i need a diagram to change timing belt on 1999 chevy malibu That engine does not have a timing belt, it has a timing chain and therefore much easier to work with as it can only go on
...is lined up on an ej20 subaru motor should the keyway be facing upwards? the one i am working on faces downwards and when i put the crankshaft/drive belt pulley on the mark doesnt line up with tdc ...
Question about Pontiac Cars & Trucks
I have a Pontiac Aztek2003 my radio works but my lights don't come on The face of the radio is soldered on the board with 15 to 20 leads. 99% of the time if you resolder them the face will light up.
Question about Cars & Trucks
...of the timing marks will show if the cams should be interchanged . The marks will either both face down, face each other or face upwards. If they face out wards away from each other then ...
Question about Cars & Trucks
...working, but the display is black? Usually bad solder joints inside the radio. Not hard to find. But you do have to remove the radio and take the case off. There are about 25 joints at the front of ...
I am facing starting problem in Fiat Palio 1.9 D I am facing problem that my Fiat Palio 1.9 D will start in first try and it will go off immediately within 1-3 seconds and then it will take much ...
Question about Toyota Land Cruiser
time 1995 buick park avenue a/c digital face and botten stoped working and is now blowing cool air out of every vent in the car all the time pls help Quite possible a blown fuse. However there is also
...If that belt goes on you, so will your engine. there is a mark on the cam shaft pulley must be face the right 90 degree.and first two cams in the cam shaft must face up and last two cams in the ...
...working. They would flicker on once in a while. I took off the face plate, cleaned the radio with a "can of air" to remove any dust, put electrical grease on the face plate contacts and the plugs on ...
364 questions posted
Usually answered in minutes!
279 Questions
212 Questions
172 Questions
141 Questions
160 Questions