...bleed screw, push the clutch pedal to the floor, close the bleed screw, repeat over and over till you are getting fluid and NO bubbles. do not reuse the brake fluid. When the bubbles are gone your ...
...system, also if empty there a leak some where. bleed system and check for leak's, look around for wetness could be a bad slave cylinder, clutch master or the line from clutch master to slave
...clutch system. (Bleed air) - Worn out master cylinder clutch, upper. (Replace) - Worn out clutch cylinder clutch, lower. (Replace). - Worn out clutch plate. (Replace) - Worn out pressure plate. ...
bleed the clutch on a 1990 toyotai just put a clutch in the clutch paddle wornt'get hard to push the to change gears Fill clutch master cylinder with fresh brake fluid. Pump a few times and hold down.
...DX 5 speed stays at the bottom and I have to pry it back up with my foot while driving. bleed the clutch some time ther is air in the master an slave cylinder or the clutch pedal needs ...
...bleed the air out of the clutch slave cylinder to get the gears but it would not last. The only way is to replace the defective master cylinder, replace all of the fluid and bleed out the air through ...
...gears ok before the clutch was replaced then the slave cylinder should be ok, it may just need bleeding. If it was playing up before, you can get them rebuilt by a brake specialist or a wrecker ...
...is probably empty and there is no fluid to operate the clutch. Try filling the reservoir and bleeding the clutch. If that does not work you will have to overhaul or replace the master cylinder ...
...clutch fluid manual Open the bleed screw and pump all the fluid out of the system . Refill with metholated spirits and repeat the operation until it is also bled out . Fill with new fluid and bleed ...
1,039 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions