1990 Toyota Pickup "wire controls 30 amp 4" Questions

Ad

...or a loose or broken wire. These breaks usually occur in the wiring harness where it goes through your door jam. the fuse is #4, it is a 30 Amp, it is located in the underhood power distribution ...

Ad

30 amp power window fuse, located underneath the steering wheel panel, and problem was temporarily resolved while switch was connected outside of driver's door panel housing. Once I secured the switch

Ad

...from above & behind, unplug the 4 plugs, spray the plugs & their sockets with the WD40, leave it work for 30 minutes, airjet spray to dry, replug & reassemble the panel &

30 amp fuse in the fuse box but can find the wiring on the rear of the truck. check inside the break light compartment. or if you have a plastic guard where you would mount a ball on your bumper, pull

...wire an jump pin 30 to 87 . in the fuse box where the relay plugs in . If the starter is good an cables an battery are good the starter should spin the engine over . 85 & 86 are the control side ...

...30 & 87 with jumper wire , it should crank the engine over . If you look on the bottom of the relay you will see 4 set's of numbers 30 & 87 are load side of the relay . If you were to test ...

...4 pins), and a fan control relay (5 pins). This allows them to be run at low speed or high speed. Check the grounds behind/under the righthand headlamp. Check Fuses 57, 58 (30 Amps) and fuse 46 (15A) ...

...Amp. 1 - Headlight, Low Beam, Left (56b) 10 2 - Headlight, Low Beam, Right (56b) 10 3 - License Plate Lights (5 10 4 - Rear Window Wiper And Washer System 15 5 - Windshield Wiper/Washer 15 6 - Fresh ...

...30 amp circuit breaker to the battery White goes to good solid ground red connects to white wire from the brake switch blue wire connects to 7 way trailer connector at rear of truck. If the truck has ...

Question about Toyota Pickup

1 Answer

...30 is Battery voltage which when energized the relay will send this B+ voltage through pin 87 to the starter solenoid turning on the starter . You could take a jumper wire an jump those 2 pins an the ...

Not finding what you are looking for?
1990 Toyota Pickup Logo

566 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...