1990 Toyota Pickup "valve" Questions

Ad

...rear tire. Locate the charcoal canister under the rear of the vehicle. The canister vent control valve is bolted to the side or the end of the charcoal canister. The valve will have a 2 pin ...

Ad

...at auction, #4 cyl. dead ran compression check 5 lbs. pressure, pulled head and found #4 exaust valve hadn't been closing for god knows how long, is there a lash setting or is it the preset valve ...

Ad

Question about Toyota Pickup

1 Answer

How difficult is it to replace valves in a 85 Toyota Pickup? It can be done, but it is classified under the engine overhaul reconditioning, which can be time consuming and expensive for an engine ...

Question about Toyota Pickup

1 Answer

what is a b p t valve Back Pressure Transducer Valve, part of the EGR system. The valve monitors and restricts too much exhaust pressure into the intake manifold from the Exhaust Gas Recirculation ...

Question about Toyota Pickup

3 Answers

...cam shaft 180 degrees out tryed to start noticed problem.corrected problem,in result intake valve appears to be staying open on cylinder 1and4.question is did i warp the valve by shaving head ...

Question about Toyota Pickup

1 Answer

...and the shafts would build up gunk and get too stiff for the choke spring to move the butterfly valves closed. I would suggest getting carb cleaner and soak the valve shafts and move them back

What is a BPT valve and does it effect the E.G.R. valve? Can you check a BPT valve? My Nissan truck manual for the same engine does not say what it is or what it does but said how to check it. It said

I was wondering how do you replace valve cover gaskets on a 1994 nissan 4 wheel drive pickup. its a v-6 3.0 theres couple bolts on the valve cover prbly 10 take them off then pull valve cover then new

rattle in the valve now has no power and hard the enginr has rattle in the valve train now has no power and hard to even start will not run very long pull valve cover and start checking your valve ...

Question about Toyota Pickup

3 Answers

valve clearance 4hj1 isuzu engine This is the specs for the 4H Diesel engine: Intake valves clearance cold 0.4mm(.016inches) Exhaust valve clearance cold 0.4mm(.016inches) Intake valve clearance cold ...

Not finding what you are looking for?
1990 Toyota Pickup Logo

566 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...