...motor and is working fine, but it wont start when hook up to the truck wiring eventhough is getting power. What should I look for? The blower motor is fed through a fan speed control whih is an array ...
...motor to idle. I used the stock carb and got it to idle but once you press the gas, the truck won't idle again. I drove it but only went 65mph. I changed the carb to a 32/36 and still can't get it to ...
...motor. It should be 3 VDC at position 1, 6 VDC at position 2, 9 VDC at position 3, and 12 VDC at the highest position. No voltage at 1/2 & 3 = replace the heater resistor, located in the air box ...
...blower motor resistor next to your blower motor,there will be wires going into it and maybe 2 bolts holding it in there,use a mirror for seeing under your dash if its hard to get at and a ...
...motor is receiving gas. i dont know what else to do. when i replaced to coil wire, the truck fired right up. and when i took it bout 2 miles down the road it died again!! still wont start!! I HAVE A ...
motor assy and usually has 4/5 wires on to it and a 2 screw fixing. This componant must be cooled (hence air duct location) and is solely responsible for motor speeds ! You can check motor fan by test
motor a 2 barrel holley it also has a lumpy idle wants 2 stall sometimes somebody said possibly an aftermarket cam do u have any suggestions on either? i love this truck wanna keep it awhile bought it
need firing order for a 318 motor in a 79 dodge power wagon firinf order is 1-8-4-3-6-5-7-2 clockwise this is for a 318 and 360 motor
heater fan moter good put new switch in and fan doesn,t work Could be the blower motor resister,it's located by blower motor,2 screw hold it on.Here's what it looks like.
...2 lower gears are out. i have replaced the switch and the fan motor and i have checked the fuses and nothing is working. any ideas on what it is Its the relay for the motor. When the relays go the ...
566 questions posted
Usually answered in minutes!
914 Questions
745 Questions
525 Questions
393 Questions
140 Questions