...clutch kit and the slave cylinder was not replaced. The car is having problems going into gear and sometimes does not want to at all. Need to replace the slave cylinder according to the person who ...
bleed the clutch on a 1990 toyotai just put a clutch in the clutch paddle wornt'get hard to push the to change gears Fill clutch master cylinder with fresh brake fluid. Pump a few times and hold down.
...system, also if empty there a leak some where. bleed system and check for leak's, look around for wetness could be a bad slave cylinder, clutch master or the line from clutch master to slave
...bleed the air out of the clutch slave cylinder to get the gears but it would not last. The only way is to replace the defective master cylinder, replace all of the fluid and bleed out the air through ...
...Try filling the reservoir and bleeding the clutch. If that does not work you will have to overhaul or replace the master cylinder or the slave cylinder. None of the above are really difficult
...DX 5 speed stays at the bottom and I have to pry it back up with my foot while driving. bleed the clutch some time ther is air in the master an slave cylinder or the clutch pedal needs ...
...bleed screw, push the clutch pedal to the floor, close the bleed screw, repeat over and over till you are getting fluid and NO bubbles. do not reuse the brake fluid. When the bubbles are gone your ...
...bleed system where it attaches to the transmission. Have someone push on the clutch pedal as you watch for movement of the clutch fork where the Slave cylinder attaches to the transmission. If the ...
Question about Toyota Corolla
...clutch is dragging (not disengaging fully) first, check for air in the system, will need to open the bleed nipple on the slave cylinder, watch for any air, but do not let the fluid level in the ...
725 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions