2005 Toyota Corolla "smart car compressor replacement" Questions

...Compressor. Ignition does not recognise smart key. Have replaced batteries in the smart key. lights all working. Do you think that I need to have the key recoded?? NO RECODING PROCEDURE EXIST FOR THE ...

...Car from the auto store I was informed that I must also purchase and change the accumulator. Is this true? And if so, is there any steps I must take to change the accumulator? The accumulator is 17 ...

...compressor is CAUSED by inadequate lubricant (not smart). Not a particularly great approach... CERTINLY more expensive than replacing the worn seal, checking/adding the oil... VACUUM testing and ...

...smart charge wiring multiplug then u will need to remove the aux belt then remove the a/c compressor . U are supposed to remove the catalyst to gain access the the alternator bolts but it can b done ...

...smart-alec, all car makers have some parts on all models that have problems, and are most often re-designed after a few years if they turn out to be "not-so-good". God bless your efforts. (From a ...

...smart thing to do is look around on ebay and elsewhere for what are called "quickstruts" this is a new strut with strut bearing and new coil spring all ready to install as one unit. so you jack the ...

...compressor did fail, then the system will require a rebuild....compoints replaced and flushing of the no replaced parts. if you answered no to thies questions then if the system is empty.... 1. to ...

...smart, it can detect alot of failures. A failed relay is one of them. In my case it started last year and when I would turn it off and then turn it on again, it would work well. Not this year. I ...

...compressor has to be replaced you're looking at a $350-$500 bill. You can do-it-yourself for the cost of supplies depending upon your level of expertise, Autozone carries the Quest/R134a ...

...unit as the AC compressor is located in the middle side of the car , behind the engine , and that wouldbe a lot easier to handle and check every thing on the car. It would take about 8 hours labor ...