2004 Toyota Land Cruiser "second" Questions

...Insert key into the ignition (Do NOT Turn) and Pull key out. 3. Perform these steps within 40 seconds. A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles starting ...

Insert the key into the ignition (don't turn it) and pull it out. 3. Perform these steps within 40 seconds: a. Cycle the power locks 5 times. Use an even pace and try to go relatively fast. b. Close,

knob. Hold down the knob until the light goes off. Before the light goes off, it illuminates for 3 seconds, flashes for 2 seconds, illuminates for 1 second

...the ignition switch to the on position. The maintenance reminder light will, illuminate for 3 seconds, blink for 2 seconds, illuminate solid for 1 second and then turn off. Release the trip ...

hi problem is when driving about every 5 miles or less dash lights come on steering heavy wipers stop but lights stay on as normal engine runs as normal started about 2 weeks ago. problem was only ...

I have Toyota Landcruiser Prado 1996 Model. For the last few months it is giving me starting problems. At times it takes a long self say for 4 to 6 seconds for starting the engine & sometimes it ...

Reset diesel filter sensor Switch the ignition to OFF. Disconnect the fuel filter warning lamp switch connector. CAUTION: Never depress the brake or clutch pedal. Switch ignition to ON. and wait for 3

...Insert key into the ignition (Do NOT Turn) and Pull key out. 3. Perform these steps within 40 seconds. A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles starting ...

how to tun off timing light after changing the belt with ignition turned on, using the trip switch , change the display to ODO, and then turn the ignition OFF While pressing the trip switch,turn the ...

How do i cancel timing belt warning light on TOYOTA prado LJ 120 R Don't know if it is the same as a 100 series landcruiser and only do it if the belt has been replaced. This is how to do it on a ...