1995 Toyota 4Runner "pull turn signal bulb socket" Questions

turn signal socket. also need tu find flasher relay making horrible noise hi there. I have a 96 4-runner and the relays are under the hood, passenger side on the fender well. Just lift the black cover

...pull out and push in. Put new bulb in, and turn the socket clockwise to tighten in place. Put battery back in, hooking up the ground first, then the positive. Turn key (or lights on if they work ...

...turn signal circuit by pull the fuses. See if you are getting the good voltage reading of (~14.5v) at the battery. IF IT'S GOOD..check for bad trailing wiring harness (isolate if possible), I've seen ...

...turn signal assembly so I can replace the bulb? Your turn signal bulb is a 1157A or 1156 bulb (either will work), and usually inserts into a connector that unscrews 1/4 turn counterclockwise, and ...

...turn. Pull socket from back of lamp. Pull bulb from socket. INSTALLATION Align key on bulb base to groove in socket and insert bulb into socket. Through access hole in wheelhouse, insert socket into ...

...pull it out. Turn the bulb socket counterclockwise 1/3 turn and remove it. Installation is the reverse of removal. Side Marker LightsRemove the screws from the marker lens and separate the lens from ...

...and pull it out. Turn the bulb socket counterclockwise 1/3 turn and remove it. Installation is the reverse of removal. You should be able to just undo 2 screws or hex bits. i could be wrong ...

...pull the light housing to the outside. 4. Turn the bulb socket counterclockwise and pull it out. 5. Pull the bulb straight out of the socket. Install in reverse order. Replacing tail/brake/backup ...

turn socket counter-clockwise 9. pull out the socket 10. pull lamp straight out 11. push in new bulb 12. reverse steps to reinstall lamp assembly Note: replacing left and right turn signal bulbs takes

Turn the bulb socket counterclockwise and pull it straight out of the lamp assembly. Pull the old bulb straight out of the bulb socket. Push the new bulb straight into the bulb socket until it clicks.