1993 Toyota T100 "unusual opposite" Questions

All 3 in the same orientation would be unusual, but not impossible. Put them in with the center one opposite the other two. + - +. If that doesn't work, reverse all 3. If that doesn't work, return it

opposite extreme. After a few seconds they go back to normal. they repeat this unusual pattern about every 2-3 minutes while I'm driving. Any ideas? Two possible fixes : 1. Replacing the GEM module. 2

Unusual for the whole controller to malfunction though, usually the button used most goes first. Unit will have fuse and relay, try swapping a like relay, and see if that solve the problem. if that is

unusual for (modern) power tools, especially circular saws, to make some strange noises when shut off - basic tools in good condition tend to stop fairly smoothly and when they don't it is often a bad

...unusual or make the noise you hear than it is bad. if everything is good start the vehicle with the belt off to confirm the noise has stopped (do not run for more 5 to 10 seconds). then reinstall the ...

...opposite, doesn't blow cold air when diling, but I figured this was the compressor. Any ideas? Also, from time to time, the fan doesn't blow anything at all. It's like it has a mind of it's own. It ...

...Unusual for the shaft to bind in the hub....better chance that the hub is stuck in the steering knuckle. To free the axle, put the nut on backwards, flush with the end of the axle so you don't ...

...unusual part, looked around nothing appeared off. Googled the part and its a throttle position sensor. I have no clue where it goes, theres no loose wires. Help Please! 1990 oldsmobile cutlass ciera ...

unusual bumps and lumps). If those items check out, turn off the car, and then check all u-joints for play (try to twist it in opposite directions) If any are worn, you know what you have to do. Also,

...unusual for all three to go bad at the same time. to check you will need to remove the door panels to gain access to the window motor. i would remove the connector to the motor and get 12v power to ...