1993 Toyota Pickup "wishbone joint" Questions

Ad

...wishbone bush has a lot of lift in it.also o/s f tyre has wear on outer rim can anybody help please. Hi, If you are experiencing grinding noises when turning, it is usually the top strut bearings ...

Ad

Wishbone, (Control Arm), anyway to remove the old joint and re-install the new one. It would be a lot easier, cheaper and a lot quicker to just replace the entire wishbone as a complete unit. Once the

Ad

...joint in the front wishbone was worn. As such I believe I need to replace the wishbone as the ball joint is joined on with rivets and I dont have a drill. How tough a job is it replacing the wishbone ...

Question about Toyota Pickup

1 Answer

...wishbone on 1st, the ball joint nut on and the front one den guide it in the hole and use a big lever with plenty of wd 40 and it will go in, i jus did one the other day, i had to change dat rear ...

Question about Toyota Pickup

1 Answer

...place ball joint in hole ,,lay wishbone on block of wood and it must sit on ball joint then get tube to go over b/joint and hit the tube which is on the w/bone hit down forcing ball joint in

Question about Cars & Trucks

1 Answer

joint/wishbone to sub frame** Toe link ball joint lock nuts Damper to lower wishbone Damper to chassis Upper brake caliper to hub carrier (M10) Lower brake caliper to hub carrier (M8) Hub bearing unit

Question about Toyota Pickup

2 Answers

...joint) -remove the bolt on the other side of the wishbone. now for the hard bit, the final two bolts. theese you get access from inside the car. -remove the rubber door seals. just give them a yank. ...

grinding or creaking in 2008 ford fusion front end noise appears randomly, but always at slow speeds and when going over bumps, etc. Mr.Mangus  have you checked at all your front suspension ...

wishbone joins to the wheel hub I can't get the knuckle in the hole in the hub any ideas? Loosen the top balljoint, release the pressure on the spring, with compressors, then swing the bottom joint in

...u must pull out the hub first and then u can see the bearing. to take out the hub u must open the cv joint nut and then the top wishbone nut and then botom wishbone nut and the last the stering rod ...

Not finding what you are looking for?
1993 Toyota Pickup Logo

626 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...