...thermostat...leave the radiator cap off and see if coolant circulates...this will also help "purge" any air in it. Hope this helps and will fixya up...good luck. backwards themostat, or water pump. ...
...required (it is not necessary to remove toothed timing belt) 3. unbolt thermostat housing and pull out from below toothed belt install the vent valve must be facing up (arrow) reverse order of ...
...thermostat comes manifold cover gasket 6. Attach intake cover to manifold 7. Attach coolant hose 8. attach lower coolant hose 9. Fill with antifreez, until almost full 10. Start up motor, (should ...
...install new thermostat in the same position it was removed and replace O ring(only use a Motorcraft replacement to avoid having fit issues) alternate tightening bolts until tight. 6. Refill radiatior ...
...thermostat which at this time i noticed the mechanic had cut the spring and valve parts of the thermostat out in order to make it free-flow. upon driving it after installing a new thermostat it ran ...
...Install the EGR valve. Connect the upper radiator hose to the thermostat housing. Connect the heater hose to the lower intake manifold. Connect the fuel pressure and return lines to the lower intake ...
...thermostat to open and coolant circulate through rad 2 or 3 times before you put cap back on. By the way, if it's just a little weeping from pump, that's normal, just so your aware. not a lot of room ...
Install the thermostat housing. a. Use a scraper to remove all traces of liquid gasket from the mating surfaces of the engine front cover and the thermostat housing. 1995 Nissan-Datsun 200SX L4-1597cc
...time. There is a thermostat in the heating elements -- it regulates the seat temperature. One must isolate the two elements & check each one individually (seat bottom - checking resistance... and ...
626 questions posted
Usually answered in minutes!
914 Questions
745 Questions
525 Questions
407 Questions
140 Questions