...idle 800 rpm max rev 3500 rpm any more causes the valves to burn out and the piston rings to break which is caused by worn bores and piston ring grooves.keep rpm down and this motor will last ...
...rpm increase after you introduce the Berryman (FUEL) at idle. Do the same starting from the brake booster unit (the round unit) on the drive side fire all. Carefully listen for increase of RPM right ...
rpm, gets 30gpm still. Any theories? or should I just turn the idle up and forget about it? Pull the plugs. Sounds like you have a bad plug or a bad plug wire. Even an engine that misses will run well
idealing rough check the fluids ok check vacume hose ok cant slove the problem the rpm needle moves up and down can anyone please help me solve my idealing problem Could be your idle air control valve
idle have you a vacuum leak does it seem to run higher rpm and did you make sure to remove all the old gasket material and not gouge the block in which it rests upon are all the vacuum lines correctly
...idle in drive or reverse, dies at stops, seems flooded when you try to start it back up. I have replace so much on this stupid car ad just want it fixed i am thinking it may be a vacum problem..get a ...
...this controls idle. turn it in and it will idle the car low take till it show 850 rpm around there and youll be ready for the smog test by the way leave the way it idles in the morning this will fix ...
idle, acceleration is lousy until about 3k rpm's then it picks up a bit but its still a far cry from what it should be doing. I checked the resistance of the primary coil was .6-.8 it should have been
nothing See if tapping the gas pedal causes the idle RPM to settle at different points. If so, it's either linkage that needs some spray lubrication or the idle air control is sticking - replace if so
226 questions posted
Usually answered in minutes!
287 Questions
200 Questions
181 Questions
212 Questions
125 Questions