1992 Toyota 4Runner "crank position sensor" Questions

...crank position sensor and produces a a/c signal, this signal go to the PCM. the crank position sensor lets the PCM were cylinder #1 is at all times, cam position sensor signal produces the the timing ...

...Crank / Cam Sensor Range / PerformancePossible causesDamaged PCM. Damaged CKP sensor. (crankshaft position sensor)Damaged CMP sensor. (camshaft position sensor)Base engine concerns. Wiring ...

...it was running grat a few days ago. If you have spark and fuel, the next stop would be either the crank position or camshaft position sensors.Either one of those can stop the engine from

...sensor, ecu, bttery,all fuses good. still will not crank same code. ill suggest if you changed the ecu you need to pair your keys with the new one. The best solution you'll get from books at ...

95 toyota 4runner no spark changed plugs and coil and igniter if you dont have any fire than check the crank position sensor

...like crazy on acceleration above 40 MPH and deceleration at almost any speed.One guy suggested it might just need tranny fluid but I can't find a spout for that. cam or crank position sensor

...crank sensors Does the light come for a short time when the key is turned on? If not, the bulb may be burned out.You should be showing that light because I suspect either the crankshaft or camshaft ...

...and the klutch wire (???). Have you replaced the Crank shaft position sensor . This on my 96 jeep is what tells every thing where the top dead center and engine speed is at. there like 70

Crank position sensor or its circuitry is faulty. replacement is reqired.2.No fuel pump or fuse is out. New pump or new fuse required.3.No spark. Coil(s) are out. New coil is required.4.Distributor is

crank sensor, and tps for shift points. Assuming the speedometer is working, I recommend you run the test below on the tps. Also put the connector back on the tps and check the voltage on terminal VTA