1991 Toyota Corolla "timing gear marks 4 cylinder" Questions

...timing chain was replaced? camshaft VVTi gear stuck on full advance..... did you aligned chain with mark on gear or front face off gear assembly? is this a new gear (VVTi) or used one this are some ...

timing belt. Upon installation one hole in each gear should face upwards and the other holes should face each other between the gears. On the exhaust cam pulley there is a hole drilled through it, ie.

...gear shiuld line up with the timing mark on the crankcase at the 1 O'Clock position. For the Camshaft gear, the small hole under the " 4A " on the gear should line up with the indent on the front ...

...timing of 10 degrees BTDC or where ever the crank was set. Tip: As the distributor goes in it will turn one way as it engages the gear So yu must lead the mark when you go to put the ditributor in by ...

...marks on the camshaft timing sprockets are in straight line on the timing chain cover surface as shown. If not turn the crankshaft 1 revolution (360°) and align the marks as above. Remove the ...

...Timing Gear 2 RH Bank Exhaust Camshaft Timing Gear 3 RH Bank No. 2 Timing Chain 4 Crankshaft 5 Idler Gear 6 Timing Chain 7 LH Bank No. 2 Timing Chain 8 LH Bank Exhaust Camshaft Timing Gear 9 LH Bank ...

...gear pulley and put the timing belt on the camshaft drive gear pulley. Secure the belt with a double clip or equivalent clip. NOTE: It is recommended for easy installation that the belt be secured ...

...Timing Marks: Click on the following Link. It has the Position of the Cranshaft and Camshaft and their respective marks. ...

...timing without special tools Turn motor till mark on crankshaft pulley or fly wheel mark lines up with TDC mark on housing. with a 4 cylinder motor turn cam shaft till valves on number 4 cylinder are ...

timing cover T D C, turn camshaft till No. 4 cylinder valves are just rocking , line up marks on crank gear with mark on head or block, we now have compression stroke on No. one cylinder, fit belt and