1989 Toyota Pickup SR5 "12 volt socket fuse" Questions

...Fuse that goes to Your Tail Lights is Good.If Not Replace it.If that does'nt WorkTake the Rear Red Lens off and take a 12Volt Tester After Removing the Bulbs and Check to see if you have 12 Volts ...

are good. wat could be the problem Bad grounds, corroded sockets or connectors. check that you have 12 volts to the sockets and the ground path is good

12 V on both sides when pedal is depressed. If voltage is present then go to multipin connector block that is near the tail light assemblies and check again for voltage, with pedal depressed or switch

...12 volt socket no longer works: the fuse The 12 volt socket on my 2004 xc90 no longer works: the fuse appears intact. Also the radio display is inaccurate but that began months before the socket ...

...12 volts to fuse socket with ignition s Checked battery, checked fuses, all good. Not getting 12 volts to 5 amp fuse for starter relay control circuit in any position of ignition switch. Getting 12 ...

...Most cars work off a 12 volt battery, therefore your power out put is 12 volt. You can buy an INVERTER which will boost power up to 230 volts (UK) Not sure what the voltage system is in the

12 volts at the bulb socket, then the bulb needs replaced with a new one. If the fuse is good and you do not have 12 volts at the bulb socket, the switch or transformer is defective. You can check the

...but can notget power to obd socket Check pin number 16 of the OBD2 connector under the dash, it should have 12 volts, if not check the fuse box diagrams for the source of the connectors B+ 12

...you do not read 12 volts at the socket, take a reading from the positive on the socket, and the engine block or battery for the negative. If you then get the 12 volts, you need to fix the ground ...

12 volt test light (avail from any auto parts store for about $4) and touch the center of the socket it should light the 12 volt test light, make sure you have a good ground or the test will