...or fuel on 88 camry 3sfe Need to check out that no spark condition. spark at coils? crankshaft position sensor bad? Ignition control module bad? These can be checked at autozone once you pull
car turns over but wont spark check your ignition control module or coil
Question about Toyota Camry
...is allowed by the following items crank position sensor cam shaft position sensor immobilizer ignition control module check that what you did to fix the engine light didn't intere with something ...
...control module and found that there is power for the light circuit when the ignition is on. Checked the cruise switch and it shows 4.4 ohms to ground at the cruise plug when it is activated. Checked ...
...Check the ignition control module located under the coils. checker/O reillys can check it once you take it out. have 1994 camery,while driving, car shuts dn,will start up again & at times will ...
...check my fuel pump when try to starty but its work you think what is the problem? If the fuel works, then most likely it is the spark. There is the crank position sensor, that is either in the ...
...Ignition Coil L Primary/Secondary Circuit MalfunctionP0370 Timing Reference High Resolution Signal A MalfunctionP0371 Timing Reference High Resolution Signal A Too Many PulsesP0372 Timing Reference ...
ignition wires, Fuel Filter , and distributor. Cleaned throttle plates, checked timing belt, idle air control valve, head gasket, fuel pump and all OK. Also dealership used black box and found nothing
ignition control module on an 1989 totota camry Toyota Camry 1983-1996 Repair Guide Ignition Module - REMOVAL & INSTALLATION External All engines, except the 2S-ELC, have an external igniter. Turn
...turns off, what could cause that? could it be ignition control module Have the IAC valve sensor checked or replaced. This controls airflow thru the intake when throttle is at a closed
388 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions