1985 Toyota Cressida "replace dash lights 20" Questions

...20 litres have been used. Is a wiring diagram available? Have a feeling it may be a faulty earth connection somewhere under the dash.? Thanks Albert have u checked the sender unit inside the tank? ...

...replace? I looked in a Haynes manual and it showed a 20 amp fuse controlling the the dash/ taillights. I t sould be in the fuse block under the the driver's side dash. If you have your owners manual, ...

...replace a burned out dash board light in a 1998 ford escort. if you buy any chilton manual from a parts store usually about 20 dollars it will show how you dash comes apart then you unscrew the ...

...lights and dash under hood while towing trailer replaced but still not working and head lights stay on My 2001 f150 blew a 20 amp fuse under hood number 5 for tail and dash lights replaced but still ...

Dash Board have to be pulled to replace the light. there could be two problems with this 1 dash fuse went not allowing it to lumanate or the bulbs went inside if the bulbs went yes you do have to take

...dash lights all go out when i try and put the turn signal on. which arnt working either. car runs fine otherwise. Your turn signal switch is multifunctioning (controls cuise, wipers, dimmer, etc.). ...

...check? For a car that’s over 20 years in age, I would say bulbs need replaced. For the dash though, check the “bright/dim” adjust for the dash lights to make sure it wasn’t turned to the off

...the box under dash. Its marked illum. lights. If it was blown and it blows again after you replace it you have a short somewhere in the circuit. P.S. your owners manual should give you fuse

...dash, headlights, etc) Similar to when an alternator goes out. Once I turn it off, let it sit for several minutes, it starts fine. Another few minutes cycle repeats. have the alternator replaced and ...

...dash light/taillights/licence plate light don't work I replaced blown 20 amp fuse, turned headlights on and blew fuse immediatly disconnect head lights, and replace fuse. Then turn the light back on ...