1984 Toyota Tercel "carburetor idling adjustment" Questions

...idling for carburator and check if its leaking Check air filter, check eventually check and replace spark plugs, and if there is a fuel filter replace it. Once you do this basic maintenance you need ...

for sure . try setting the idle at a higher level. look for the adjustment screw near the carburetor. it is easily distinguished either by a big screw or a plastic screw that looks off from the others

...carburetor or fuel injection? Does it have contact breakers and a condenser int he distributor or is it equipped with an electronic ignition system? Before we go onto the steering and suspension, ...

...idling down' when the weight of the vehicle puts a load on the motor. In other words, does it idle down, or does it only SEEM like it is, because now it's pulling the car? Do you have to give it gas ...

...adjustment? my carburetor idles high and goes back to normal idle after 5 minutes of not reving...it also idles high when the clutch pedal is pressed...the adjustment screws (mixture and idle)are at ...

...adjustment screw on my 1971 350 cu. in. El Camino Carburator Remove the air cleaner to access the carburetor. Note the right side of the carburetor where the accelerator cable is connected. The cable ...

carburetor rebuilt or new without making idle and linkage adjustments to match the engine requirements. Does it have an idle solenoid adjustment and kick down adjustment, double barreled?. Did you get

how do you adjust the carburetor on my 83 buick regal limited 4.1L-v6 my car idles to low and i was told i need to adjust the carburetor how do i do that? There should be an idle control motor on the ...

idling. how do i adjust the idle If it has fuel injection it cannot be adjusted. If it has carburetor then one can turn a screw on the carburetor, but I think that your 1992 Nissan has fuel injection

...adjustment, leave the carburetor alone for approximately one hour at 73°F (23°C). Adjust the fast idle opening by turning the fast idle adjusting screw to the following specified values ...