1984 Toyota Celica Supra "noid light flashes goes" Questions

noid light for the injectors, disconnect on injector electical connetor connect the noid light to the wire that u just unplugged from the injector. the light will flash while u crank , once it goes to

...noid light to check for power to the injectors on that side. Noid should flash with engine turning over, if no signal check the fuse for the injectors .If it is blown check inj wiring for short to ...

...noid light at injector connector,lights not flashing,still has spark. reinstalled plugs,and coil tower,then pullled out the cam sensor, had a tiny build up on the tip of the sensor,cleaned off sensor ...

...Noid light test.

Whether you're testing a No Start Condition or a Misfire Condition, you'll need to know if the cause of the problem is a lack of fuel. When your GM 3.8L (Buick, Chevrolet, ...

...noid light .You disconnect the injector connector an plug the noid light in . This light will flash if the circuit is good . You could also use a test light hooked to the positive battery terminal ...

NOID and crank it. test , 1. key on, if the lamp glows. the ECU is bad. shorted. test 2: key on , crank it ,does the light flash, or seem to glow? now it flashes so fast it can seem to just glow. now.

...light goes out. 4) as soon as light goes out vehicle should start. if it does not crank engine again until it starts. 5). when engine starts flip toggle switch to the off position then security light ...

...noid'' light. Light blinks when first started but goes out and then engine quits. Is this a possible ECM problem when it goes from open loop mode to ECM control? Can original ECM be diagnosed out of ...

...noid light to plug into the injector plug and it should flash if you have injector pulse. If no pulse check ignition module in the distributor. If not that re-post and we can go from there. Have a ...

...noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal to the injectors from the ...